Paso 1
Apply your thread down the shank of the fly and stop at the start of the hook bend, cut your tag end
Paso 2
Cut a small hunk para post off of the main strand approximately double the size of the hook shank and tie 1/6 of that clump in measured against the shank
Paso 3
Pinch and twist a very small amount of dubbing with a tapered profile and then dub it on 2/3 of the shank
Paso 4
Leave 1/3 of the hook shank open for the thorax and cdc Loopwing
Paso 5
Tie in the tip of 1 cdc feather in at the front of the hook just behind the eye back to the end of the 2/3 abdomen and the start of the thorax
Paso 6
Dub a thick thorax slightly larger than the biggest part of the abdomen and leve a small spot just behind the eye to tie down the cdc
Paso 7
Fold the cdc feather forward making a small loop about half the size of the body and secure with two thread wraps, you can also use your bodkin to assist you in making a loop by placing it in between the thorax and cdc while lifting up and releasing tension on your bobbin and lifting up and back to make the loop larger
Paso 8
Apply a extremely small amount of dubbing to your thread and dub over whether the cdc is tied in and just behind the eye
Paso 9
After you dub wip finish and cut your thread
Paso 10
Done
